Estogard PU S600
Estogard CS50e
Show all

Estogard PU10

Self-smoothing, Thin Layer Underlayment

Download Data Sheet

Estogard PU10

Polyurethane Floor Coating


Estogard PU10 is a two component polyurethane system. It has excellent adhesion to cementitious and metal surfaces and when cured forms a semi-gloss flexible film. It penetrates the surface to bind together the particles to produce a harder wearing surface.


As a clear/pigmented sealing coat on cementitious floors or on metal substrate to provide a dustproof and more easily cleaned surface with resistance of penetration of oils and liquids, ideal for warehouse, house, garages, indoor car parks, light industrial buildings.


  • Easily laid – simple brush application.
  • Durability – good resistance to abrasion.
  • Non- dusting – totally seals the concrete surface preventing dusting.
  • Chemical resistance – excellent resistance to chemical and staining.
  • UV resistance – excellent weathering resistant properties.


Physical Properties

Finishing Gloss
Color Clear or colored
Volume Solids 45 ± 2%
Drying Time at 25 ̊ C: Touch Dry



4 – 6 hrs

24 hrs

Pot Life 4 hours
Temperature Resistance 150 ̊ C for dry service
Recommended Thickness 45 microns DFT


Application Instructions


Concrete Surface

The substrate must be cleaned, dry and free from all contamination.

Steel Surface

All surfaces should be grit blasted before application of Estogard PU10.


Stir Part A thoroughly in the containers with power mixer, then pour Part B into Part A in the pre-weighed packing and continue  to stir. Mix to a uniform consistency before application.


Pour the contents of the Estogard PU10 into a plastic bucket or similar and apply to the surface to be treated with soft brush until an even coverage is obtained.

A continuous coating of uniform thickness should be allowed between coats.

Total 2 coats of Estogard PU10 to be applied on the prepared substrate. For optimum adhesion, concrete substrate should be primed with Estoprime LV and allow drying.


The rate of curing is dependent on temperature and other environmental conditions. Provide good ventilation immediately after application to ensure proper curing.


 Clean tools and equipment immediately after use.

Packing & Size


  Estogard PU10                      5 litre pack                            
   Estoprime LV                        5 kg pack                              


Estogard PU10 9 – 10 m2 per litre per 45 microns DFT
Estoprime LV 5 m2 / kg

These figures are for guidance only. Actual coverage will depend on the texture and porosity of the surface being covered.

Technical Support

Estop offers a comprehensive range of high performance, high quality of product for both new and existing concrete surfaces, in addition, the company offers a technical support package to specifiers, end-user and contractors, as well as on-site technical assistance.


Estogard PU10 should be stored on pallets in cool and dry conditions. The product shelf life is of 6 months.

It shall be protected from high humidity and extreme heat.


Contact with the skin must be avoided. Gloves and barrier cream should be used when handling these products. If contact with the resin occurs, the skin should be washed immediately with soap and water. Eye contamination must be immediately washed with copious quantities of water and medical treatment sought.

Estogard PU10 is flammable. No naked flames allowed. Do not smoke during use.

Additional Information

Estop manufactures and offers a wide range of complementary products, which includes waterstops, waterproofing products, grouts, anchors, specialized flooring products. In addition, a wide range of products formulated for repair and refurbishment of spalled concrete are available.