High Concentration Oild Based Mould Releasing Agent
Download Data SheetEstop Estoform HP specially blended in high concentration and with high efficient releasing properties.
It is specially design to provide quick, clean and easy stripping of moulds and formworks.
Specific Gravity | 0.9 at 25 °C |
---|---|
Colour | Pale straw |
Service Temperature | 70 °C max |
Non-staining | Can be safely used with white cement |
No surface preparation is required, as long as the substrate is clean.
All adherent materials must be removed prior to use.
Mix Estoform HP with diesel prior to application to formwork. The mixing ratio of Estoform HP to diesel shall be 1:20.
The mixing process is simple. Fill 10 litre of Estoform HP into 210-litre capacity empty drum and then fill with 200 litre of diesel. If diesel being filled first, roll the drum to ensure even mixing.
Use brush, sponge or conventional mould oil sprayer to apply mixed Estoform HP. The correct nozzle size should be ensured, if a sprayer is used. Ponding or accumulation of excess mould oil should be avoided. It should be applied in a continuous even film.
If there is a delay period for more than 48 hours, the surface should be recoated. Non-absorbent surfaces shall be applied in a single layer only.
The moulds or formworks shall be clean before application of Estoform HP.
The spillages of Estoform HP should be absorbed into sand, earth or vermiculite and transfer to suitable container.
Estoform HP | 10 litre pail |
---|
Estoform HP | 20 to 60 m2/litre after mixed, depend on type and porosity of mould used |
---|
Estop offers a comprehensive range of high performance, high quality of repair product for both new and existing concrete surfaces. In addition, the company offers a technical support package to specifies, end-users and contractors, as well as on-site technical assistance.
Estoform HP should be stored on pallets under dry conditions in original un-open drum. Under these conditions the product will have a shelf life of 12 months.
If stored in extreme heat locations the shelf life may be reduced.
The flammability risk of Estoform HP is low. Adequate ventilation should be ensure when use. Do not use near naked fire or smoke during use.
Estoform HP should not be swallowed and avoid to be in contact with skin or eyes. Wear gloves and goggles for protection. If swallowed, seek medical attention immediately
Do not induce vomiting.
Estop manufactures and offers a wide range of complementary products which includes waterstops, waterproofing products, grouts, anchors, specialized flooring products. In addition, a wide range of products formulated for repair and refurbishment of spalled concrete are available.